Zhejiang Jinbang Sports Equipment Co., Ltd. operates its own PU wheel line, and its workshop description covers wheel diameters from 20 mm to 250 mm. The PU wheels page presents that line as a manufacturing capability. A buyer specifies scooter wheels three ways: as replacements for a scooter range, as original equipment on a scooter programme, or as a retail wheels line in its own right. The questions are selection questions — which diameter, which hardness direction, which core construction, for which scooter — and every answer is confirmed per reference in writing at quotation.
The four decisions, applied to scooters
A scooter wheel becomes precise with the same four decisions the PU wheels page sets out. Diameter, chosen from the 20 mm to 250 mm production span to match the scooter's ride height and the position the wheel serves, front or rear. Hardness, expressed as a durometer direction stated with the surface and the riding the wheel is bought for, and settled on samples rather than asserted in the abstract. Core construction, specified explicitly rather than left to a default, above all on stunt and high-load applications. And colour and, where the programme asks about it, light-up construction: how a light-up wheel produces its effect is a fact of the individual construction, confirmed model by model, and whether a light-up construction is supplied for a given order is confirmed in writing at quotation, not asserted from the line's general description.
Replacement fitment
A replacement wheel is specified against its parent. State the parent scooter's JB reference, the wheel position and the existing wheel's dimensions as you measure them, and ask for the matching wheel to be confirmed against that record. Bearing seats, spacer tolerances and surface finish belong in the written specification. Whether a production run is checked against an approved sample is not a standing rule of this line: it is a programme term — raise it in the enquiry, agree it for the programme and record it in writing, rather than leaving it to assumption. The electric scooter parts page takes the same written route for the parts side of a programme. A wheel sold as a replacement part should be specified like one: against the parent reference, with the dimensions stated in writing.
Colour and programme details
Wheel colour is a specification item in its own right. Programmes can state wheel colours to match the decks and frames of the finished scooters, with the colourway for the exact wheel specification confirmed in writing and on samples. Consistency between a sample and a later production run is a question a bulk buyer can put in writing for the programme: agree the reference at first order — a written specification and retained approved samples that both sides check reorders against — rather than assuming a match that was never recorded.
Wheels for skateboards
The board side of the catalogue has its own selection page. Buyers specifying wheels for complete skateboards, or as a standalone board-parts line, should use the skateboard wheels page, where the selection conversation is framed for board programmes. Whether the wheels for a given board programme are supplied from this line is not stated by the catalogue layout: it is confirmed per reference in writing at quotation — the same confirmation route and documentary discipline as on this page.
Ordering information
Send your application, diameter and hardness direction, parent references where relevant, and quantity pattern to [email protected] to request a quotation. Wheel MOQ and lead time are confirmed per quotation, for the specification stated in the enquiry. For documentation supporting your market: Certificates available upon request.
Send model references, your target market and branding requirements — MOQ and lead time are confirmed per quotation in writing.
Request a Quotation